If all has gone well, the guitar is done!
The simplest varieties, however, simply require a few screws to fix the bridge in place.
Consider buying the neck.
Finally, for a rosewood fretboard, you will need to laminate the board to the neck.The pickups you purchased should come with a schematic that shows exactly how to connect these to the controls and to the input for the guitar cord.There are a number of types of bridges, so the exact directions for attaching yours will depend on its design.By using this service, some information may be make your website searchable on google shared with.12 Neck widths are usually about.51.75 inches (3.84.4 cm) at the nut, and widen slightly as the frets get higher.Measurements need to be highly precise, so use a spacing template (available online).Set it up Once it is all put together, youll need to make some adjustments to your guitar before it is ready to play.



4 5, make sure you have the necessary tools and know-how.
Strings 4, buy a pre-manufactured neck.
If the neck is made by yourself, you needtake two boards of ash and one of pine.
You need to look at how the fibers are distributed.
The more symmetry, the better.Here are some of the most popular choices: Maple: A hard wood that delivers a bite.You will cut the wire to make the basic length of each fret, hammer it in, and then trim it to be flush with the neck.Select a wood size based on the thickness of an existing guitar, or on what feels comfortable to you.Route the body, with the body of the guitar formed, you need to route out spaces for the hardware.A natural place to start is deciding on the body type you want.Lay the cut-out of your guitar body design on the wood you selected, and trace the design onto.If you want to make the process easier, you could try purchasing an electric guitar kit.For this, a rod with threaded ends, washers and nuts is used.